Pilot 4WD V6-3.5L (2008)
7. Install the snap ring (F).
8. Pack the inboard joint with the joint grease included in the new inboard boot set.
9. Right driveshaft: Fit the inboard joint onto the driveshaft, and note these items:
^
Reinstall the inboard joint onto the driveshaft by aligning the marks (A) you made on the inboard joint and the rollers.
^
Hold the driveshaft so the inboard joint points up to prevent it from failing off.
10. Left driveshaft: Install the inboard joint onto the driveshaft by aligning the mark (A) you made on the inboard joint and bearing (B).
11. Install the circlip (C).
12. Fit the boot (A) ends onto the driveshaft (B) and the inboard joint (C).