Pilot 4WD V6-3.5L (2008)
6. Apply multi-purpose grease to the interior lip of the new outer seal (A). Install the outer seal into the bearing support (B) using the support base
attachment (C), 39.2 x 49.5 x 15 mm fork seal driver (D), support base (E), and a press.
7. Install the heat shield onto the bearing support.
Rear Driveshaft Disassembly
Rear Driveshaft Disassembly
Special Tools Required
^
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
^
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the boot bands. Be careful not to damage the boot.
^
If the boot band is a welded type (A), cut the boot band.
^
If the boot band is a double loop type (B), lift up the band end (C), and push it into the clip (D).
^
If the boot band is a low profile type (E), pinch the boot band using a commercially available boot band pliers (F).