Pilot 4WD V6-3.5L (2008)
10. Install the boot bands.
^
For the low profile type, go to step 11.
^
For the double loop type, go to step 14. (Boot band replace only)
11. Install the new low profile band (A) onto the boot (B), then hook the tab (C) of the band.
12. Close the hook portion of the band with a commercially available boot band pliers (A), then hook the tabs (B) of the band.
13. Install the boot band on the other end of the boot, and repeat steps 11 through 12.
14. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot (B).
NOTE: Pass the end of the new double loop band through the clip (C) twice in the direction of the forward rotation of the driveshaft.