S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
6. Bleed the clutch hydraulic system. Tighten the bleeder screw to 9.8 Nm (1.0 kgf-m, 7.2 ft. lbs.).
NOTE: Be careful not to damage the slave cylinder by overtightening the bleeder screw.
^
Attach a hose to the bleeder screw (A), and suspend the hose in a container of brake fluid.
^
Make sure there is an adequate supply of fluid at the clutch master cylinder, then slowly pump the clutch pedal until no more bubbles appear at
the bleeder hose.
^
Refill the clutch master cylinder with fluid when done.
^
Always use only Genuine Honda Brake fluid or an equivalent DOT 3 or DOT 4 brake fluid.
^
Confirm clutch operation, and check for leaking fluid.