S2000 L4-2.2L (2004)
Axle Shaft Assembly: Service and Repair
Removal and Installation
Removal
Special Tools Required
^
Ball joint remover, 28 mm 07MAC-SL00200
1. Loosen the wheel nuts slightly.
2. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
3. Remove the wheel nuts and rear wheels.
4. Lift up the locking tab (A) on the spindle nuts (B), then remove the nut.
5. Remove the cotter pin (A) from the lower arm ball joint castle nut (B), and remove the nut.
6. Separate the ball joint from the lower arm (C) with the special tool.
7. Remove the ABS sensor harness (A) from the upper arm.