H1 V8-6.5L DSL (1998)
-
If the resistance is between 10 and 50 ohms, continue test.
-
If the resistance is not within the specified range, the problem is an open wire, a bad connection, or a failed stepper motor.
6. Check the resistance between terminals A9 and A10 of the brown 24 pin PCM harness connector (C29) coil 2 low (A9), and coil 2 high (A10)
(Figure 3-19).
-
If the resistance is 10-50 ohms, the problem is in the PCM connection, or the PCM.
-
If the resistance is other than specified, the problem is in the wires to the PCM coil 2 terminals, a bad connection, or the PCM has a fault.
