Fuel Tank Unit Service and Repair Procedures
6. Remove bolts and nuts attaching tank skid plate to left and right frame brackets and rear crossmember.
7. Lower tank enough to reach fuel lines. Then disconnect fuel lines, fuel level transmitter wires, and vent line. Mark lines and wires for assembly
reference.
NOTE: The fuel supply and return lines are equipped with quick connect fittings. To disconnect, first lift and remove the fitting retainer from
each fitting. Then pull the fittings free of the tank fuel tubes.
8. Lower the jack and remove the tank from under the vehicle.
Figure 3-34: Fuel Tank and Components
9. Replace fuel level transmitter and access plate (Figure 3-34).
Installation
1. If new tank is being installed, transfer tank skid plate to new tank.
2. Place tank on floor jack and position it under vehicle.
3. Raise tank enough to reach feed lines.
4. Attach vent line and fuel level transmitter wires.