H2 V8-6.0L (2004)
Wiring Harness: Service and Repair
Wiring Harness Replacement - Rear Door
WIRING HARNESS REPLACEMENT - REAR DOOR
REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the water deflector.
3. Disconnect the speaker electrical connector.
4. Disconnect the window motor electrical connector.
5. Disconnect the door lock actuator electrical connector.
6. Remove the wiring harness from door through the pass through hole (2) by releasing all retainers, noting their location for reinstallation.
7. Disconnect the door harness from the body harness (2).
INSTALLATION PROCEDURE
1. Route the wiring harness through the pass through hole (2), ensuring that the rubber grommet seal is fully seated.
2. Connect the door harness to the body harness (2).
3. Fasten the wiring harness to the door by attaching all retainers in their proper location.
4. Connect the door lock actuator electrical connector.
5. Connect the window motor electrical connector.
6. Connect the speaker electrical connector.
7. Operate all electrical door components to ensure proper operation.
8. Install the water deflector.
9. Install the door trim panel.
