H2 V8-6.0L (2004)
1. When replacing a VCIM, record the 11-digit electronic serial number (ESN) and the 10-digit station identification (STID) number from the label
on the new VCIM.
2. Connect the electrical and the antenna connections to the communication interface module.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the communication interface module screws.
Tighten
Tighten the screws to 2 N.m (18 lb in).
4. Install the I/P center trim panel.
IMPORTANT: After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to reconfigure the
system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this
version of the OnStar(R) system. This action will cause a DTC to set.
5. Reconfigure the OnStar(R) system. Refer to OnStar(R) Reconfiguration
