H2 V8-6.2L (2008)
Place a small amount of Instant Adhesive Gel, P/N 12345632 (in Canada, P/N 10953475) or equivalent to the top of the upper mount in order
to hold the upper insulator in position during installation.
6.
Raise the vehicle to seat the body on the frame and tighten the right side mounts.
7.
Install the jack stands on the left side of vehicle to support the body.
8.
Loosen the lower body mounts on the left side.
9.
Slightly lower the vehicle just enough to provide access to the left side upper body mounts.
10.
Remove the upper body mounts one at a time and install the insulators.
11.
Raise the vehicle to seat the body on the frame.
12.
Tighten all body mounts.
Tighten
Tighten to 85 N.m (63 lb ft).
13.
Remove the jack stands.
14.
Lower the vehicle.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
