H2 V8-6.2L (2008)
6. Remove the bolts from the latch mechanism. Note the cable bolt is shoulder for the cable.
7. Carefully pull the latch outward and release the lock rod clip (3) from the lock rod (4).
8. Remove the latch from the endgate.
Installation Procedure
1. Position the latch to the endgate.
2. Connect the lock rod (4) to the latch and secure the lock rod clip (3).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Push the latch inward and install the bolts. Note the cable bolt is shouldered.
Tighten the latch bolts to 25 N.m (18 lb ft).
