H2 V8-6.2L (2008)
Brake Pedal Assy: Service and Repair
Brake Pedal Assembly Replacement
Removal Procedure
1. Without disconnecting the electrical connector, remove the stop lamp switch. Refer to Stop Lamp Switch Replacement (See: Lighting and
Horns/Brake Light Switch/Service and Repair) .
2. Remove the nut from the brake pedal bolt.
3. Remove the brake pedal bolt.
4. Remove the brake pedal.
Installation Procedure
1. Install the brake pedal.
2. Install the brake pedal bolt.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the nut to the brake pedal bolt.
Hold the nut stationary and tighten the brake pedal bolt to 47 N.m (35 lb ft).
4. Install the stop lamp switch. Refer to Stop Lamp Switch Replacement (See: Lighting and Horns/Brake Light Switch/Service and Repair) .
