H2 V8-6.2L (2008)
1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
*
Remove all traces of the original adhesive patch.
*
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
*
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488).
Notice: Refer to Fastener Notice .
3. Install the caliper bracket mounting bolts (2).
Tighten the caliper bracket mounting bolts to 165 N.m (122 lb ft).
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads to the brake caliper bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper. Refer to Front Brake Caliper Replacement (See: Front Brake Caliper Replacement) .
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
