H2 V8-6.2L (2008)
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Clean all dirt and foreign material from the brake hose and brake pipe fittings.
Important: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
3. Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end.
4. Remove the brake hose upper bracket bolt.
Important: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
5. Using a backup wrench on the hose fittings, disconnect the brake pipe fittings from the brake hoses (1), then cap or plug the brake pipe fitting
ends.
6. Remove the brake hose lower bracket bolt (2).
7. Remove the jounce hoses.
Installation Procedure
