H2 V8-6.2L (2008)
8. Release the power brake booster inlet hose clamp (1), disconnect the hose and remove the master cylinder reservoir (2).
9. Remove the 2 master cylinder reservoir grommets from the master cylinder, if necessary.
Installation Procedure
1. Install the 2 master cylinder reservoir grommets to the master cylinder, if removed.
Important: Apply a small amount of clean brake fluid from a sealed container to the master cylinder reservoir grommets prior to
installing the reservoir.
2. Release the power brake booster inlet hose clamp (1), connect the hose and install the master cylinder reservoir (2).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
