H2 V8-6.2L (2008)
6. Install the brake master cylinder pushrod retainer bolt (1).
Tighten the bolt to 10 N.m (89 lb in).
7. Install the knee bolster. Refer to Driver Knee Bolster Replacement (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Driver Knee Bolster Replacement) .
8. Install the 2 front brake pipes (1) to the brake master cylinder.
Tighten the fittings to 25 N.m (18 lb ft).
9. Connect the electrical connectors at the brake pressure modulator valve (BPMV).
10. Connect the brake fluid level sensor electrical connector.
