H2 V8-6.2L (2008)
6. Remove the right assist step if necessary. Refer to Assist Step Replacement (w/WS2, BVX) (See: Body and Frame/Auxiliary Step / Running
Board/Service and Repair/Assist Step Replacement (w/WS2, BVX))Assist Step Replacement (Tubular BVE) (See: Body and Frame/Auxiliary
Step / Running Board/Service and Repair/Assist Step Replacement (Tubular BVE)) .
7. Remove the front wheelhouse liner if necessary. Refer to Wheelhouse Panel Replacement (See: Body and Frame/Fender/Front Fender/Front
Fender Liner/Service and Repair) .
8. Remove the auxiliary heater tubes connector nuts (2) from the intermediate connection point.
9. Remove the auxiliary heater tubes clip push pins (1) from vehicle frame locations.
10. Remove the auxiliary heater tubes (2) from vehicle.
11. Remove auxiliary heater tubes clip retaining push pin/bolt (1) if necessary.
12. Use a flat blade release tool to open retaining clips (2).
13. Remove auxiliary heater tubes (3) from retaining clips.
Installation Procedure
Important: The replacement A/C and heater pipes are shipped in front and rear sections.