H2 V8-6.2L (2008)
Valve Cover: Service and Repair
Valve Rocker Arm Cover Replacement - Right Side
Valve Rocker Arm Cover Replacement - Right Side
Removal Procedure
1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) (See: Intake Manifold/Service and
Repair/Upper Intake Manifold Sight Shield Replacement) .
2. Remove the connector position assurance (CPA) lock (5).
3. Disconnect the main electrical connector (4) feeding the ignition coils.
4. Remove the harness clips (1).
5. Reposition the engine harness.
6. Remove the spark plug wires from the ignition coils.
*
Twist each plug wire 1/2 turn.
*
Pull only on the boot in order to remove the wire from the ignition coil.
7. Reposition the surge tank/heater hoses from the heater hose bracket.
8. Remove the heater hose bracket nut and bracket.
9. Remove the ignition coil bracket studs from the rocker arm cover.
10. Remove the ignition coils and bracket from the rocker cover.
11. Remove the positive crankcase ventilation (PCV) fresh air hose.
