H2 V8-6.2L (2008)
Intake Manifold: Service and Repair
Intake Manifold Replacement
Intake Manifold Replacement
Removal Procedure
Important: The intake manifold, throttle body, fuel rail, and injectors may be removed as an assembly. If not servicing the individual
components, remove the manifold as a complete assembly.
1. Remove the throttle body. Refer to Throttle Body Assembly Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle
Body/Service and Repair/Removal and Replacement) .
2. Remove the fuel injectors. Refer to Fuel Injector Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Injector/Service and Repair/Removal and Replacement) .
3. Disconnect the following electrical connectors:
*
Manifold absolute pressure (MAP) sensor (1)
*
Knock sensor (2)
4. Remove the knock sensor harness electrical connector from the intake manifold.
5. Set the electrical harness aside.
6. Remove the MAP sensor (1) from the intake manifold.
