H2 V8-6.2L (2008)
8. Remove J 22794 from the spark plug port.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
9. Hand start the spark plug.
Tighten the spark plug to 15 N.m (11 lb ft).
10. Install the spark plug wires at the ignition coil.
11. Install the spark plug wire to the spark plug.
12. Inspect the wires for proper installation:
*
Push sideways on each boot in order to check for proper installation.
*
Reinstall any loose boot.
13. Install the valve rocker arm. Refer to Valve Rocker Arm and Push Rod Replacement (See: Camshaft, Lifters and Push Rods/Rocker Arm
Assembly/Service and Repair) .
