H2 V8-6.2L (2008)
1. Install the new sealing washers. Refer to Sealing Washer Replacement (See: Coupler HVAC/A/C Coupler O-ring/Service and Repair/Sealing
Washer Replacement)
2. Install the discharge hose (3) to the vehicle.
3. Install the discharge hose (3) to the condenser (2).
Notice: Refer to Fastener Notice .
4. Install the nut (1) to the condenser (2).
Tighten the nut to 16 N.m (12 lb ft).
5. Install the discharge hose (5) to the A/C compressor (4).
6. Install the discharge hose bolt (6) to the A/C compressor (4).
Tighten the bolt to 16 N.m (12 lb ft).
7. Install the A/C recirculation switch to the discharge hose (5) .
8. Connect the electrical connector to the A/C recirculation switch.
9. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging (See: Service and Repair/Refrigerant Recovery and
Recharging) .
10. Leak test the fittings of the component using the J 39400-A .
Suction Hose Replacement
Suction Hose Replacement
