H2 V8-6.2L (2008)
1. Install the bulbs into the sockets (3).
2. Position each socket into the lamp (1) and rotate 1/8 turn in order to secure.
3. Position the lamp housing (1) to the rear body opening.
Important: The outboard edge of the lamp housing will need to be positioned first.
4. Connect the lamp housing electrical connector to the main body wire harness connector.
5. Ensure all electrical wiring is positioned away from the sharp sheet metal flanges.
6. Secure the inboard side of the lamp (1) to the endgate opening.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
7. Install the screws (2).
Tighten the screws to 6 N.m (53 lb in).
