H2 V8-6.2L (2008)
Engine Oil: Technical Service Bulletins
Engine - Oil Consumption Verification
INFORMATION
Bulletin No.: 03-06-01-023A
Date: December 17, 2008
Subject:
Higher Than Expected Oil Consumption at 8600 GVW and Above
Models:
2000-2009 Chevrolet Express, Silverado, Suburban
2002-2009 Chevrolet Avalanche
2003-2009 Chevrolet Kodiak C4500-C5500 Series Models
2000-2009 GMC Savana, Sierra, Yukon XL
2003-2009 GMC TopKick C4500-C5500 Series Models
2003-2009 HUMMER H2
with Gasoline Engine and Rated at 8600 GVW and above
Supercede:
This bulletin is being revised to update the model years. Please discard Corporate Bulletin Number 03-06-01-023 (Section 06 - Engine/Propulsion
System).
Information on Engine Oil Consumption Guidelines
All engines require oil to lubricate and protect the load bearing and internal moving parts from wear including cylinder walls, pistons and piston rings.
When a piston moves down its cylinder, a thin film of oil is left on the cylinder wall. During the combustion process, part of this oil layer is consumed.
As a result, varying rates of oil consumption are accepted as normal in all engines.
Oil Consumption
Oil usage has a direct relationship with the amount of fuel used. The harder an engine works, the more fuel and oil it will use. Therefore, oil usage as a
factor of fuel usage is a more accurate indicator of acceptable oil consumption levels than vehicle mileage for vehicles at or above 8600 GVW.
The accepted rate of oil consumption for gasoline engines in vehicles at or above 8600 GVW is 0.946 liter (1 qt) within 379 liters (100 gallons) of fuel
used. This rate only applies to vehicles under warranty, maintained in accordance with the appropriate maintenance schedule, driven at legal speeds and
within design intent of the vehicle.
Many factors can affect an owner's concern with oil consumption. Driving habits and vehicle maintenance vary from owner to owner. Thoroughly
evaluate each case before deciding whether the vehicle in question has abnormal engine oil consumption.
Gasket and External Leaks
Inspect the oil pans, engine covers, and the engine oil cooler for leakage. Inspect for oil leakage into the engine coolant.
Improper Reading of the Oil Level Indicator (Dipstick)
The vehicle must be parked on a level surface to obtain accurate oil level readings. Verify that the dipstick tube is fully seated in the block. When
checking the oil level, make sure the dipstick is wiped clean before taking an oil level reading and fully depress the dipstick until the shoulder bottoms
out on the dipstick tube. The dipstick should be the proper part number for the engine/vehicle that is being checked.
Not Waiting Long Enough After Running Engine to Check Oil Level
The vehicle should be allowed to sit for at least 15 minutes, after the engine has been shut off, before taking an oil level reading to assure the oil has had
enough time to drain back into the crankcase. In order to ensure accurate results, the temperature of the oil should be close to the same temperature as the
last time the oil level was checked.
Improper Oil Fill After an Oil Change
Following an oil change, verify that the proper amount and type of oil was put in the engine and that the oil level on the dipstick is not above the full
mark or below the add marks. Refer to the Owner's Manual or Service Manual for information on recommended oil quantity, viscosity, and quality.