H2 V8-6.2L (2008)
Fuse Block: Service and Repair
Instrument Panel Electrical Center or Junction Block Replacement - Right Side
Instrument Panel Electrical Center or Junction Block Replacement - Right Side
Removal Procedure
1. Remove the right side end panel.
2. Push in the tabs in order to remove the fuse block.
3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
4. Loosen the bolt.
5. Insert a screw driver between the wire harness block and fuse block in order to separate.
6. Separate the fuse block from the I/P harness block.
7. Remove the IP wiring harness block from the vehicle.
Installation Procedure
1. Install the fuse block to the I/P wire harness block.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the retaining bolt.
Tighten the bolt to 6 N.m (53 lb in)
3. Install the fuse block to the I/P till it clicks in place.
4. Connect the wiring connectors to the fuse block.
Refer to Electrical Center Identification Views (See: Fuse/Application and ID) to ensure the right connections are made.
5. Install the right side end panel.
