H2 V8-6.2L (2008)
Crankshaft Position Sensor: Removal and Replacement
Crankshaft Position Sensor Replacement
Removal Procedure
Important: Perform the Crankshaft Position System Variation Learn (See: Procedures) when the crankshaft position sensor is removed or
replaced.
Caution: Refer to Battery Disconnect Caution (See: Starting and Charging/Battery/Service Precautions/Technician Safety Information/Battery
Disconnect Caution) .
1. Disconnect the negative battery cable.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
3. Remove the starter. Refer to Starter Motor Replacement (See: Starting and Charging/Starting System/Starter Motor/Service and Repair) .
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
6. Remove the CKP sensor retaining bolt.
7. Remove the CKP sensor.
Installation Procedure