H2 V8-6.2L (2008)
1. Apply sealant to the threads of the oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants (See: Engine, Cooling and
Exhaust/Engine/Specifications/Sealers, Adhesives, and Lubricants) for the correct part number.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Using J 41712 or equivalent, install the oil pressure sensor.
Tighten the oil pressure sensor to 35 N.m (26 lb ft).
3. Connect the oil pressure sensor electrical connector (1).
4. If necessary, install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) (See: Engine, Cooling and
Exhaust/Engine/Intake Manifold/Service and Repair/Upper Intake Manifold Sight Shield Replacement) .
