H2 V8-6.2L (2008)
1. Install the WSS (5) into the hub/bearing assembly (4).
Notice: Refer to Fastener Notice .
2. Install the WSS mounting bolt.
Tighten the WSS mounting bolt to 18 N.m (13 lb ft).
3. Install the WSS cable mounting clip to the knuckle.
4. Install the WSS cable mounting clip to the upper control arm.
5. Install the WSS cable mounting clip to the frame attachment point.
6. Connect the WSS cable electrical connector.
7. Install the brake rotor. Refer to Front Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Front Brake Rotor Replacement) .
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
9. Return to Diagnostic Starting Point - Antilock Brake System (See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Starting Point - Antilock Brake System) .
