H2 V8-6.2L (2008)
Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement (See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Engine
Oil/Service and Repair) .
2. Disconnect the oil level sensor electrical connector (6).
3. Remove the oil level sensor from the oil pan.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the oil level sensor to the oil pan.
Tighten the oil level sensor to 13 N.m (115 lb in).
