H2 V8-6.2L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Use installer J 29193 or installer J 29194 to seat the idler arm and pitman arm to the relay rod.
Tighten the installer to 54 N.m (40 lb ft).
3. Install the new pitman arm nut.
Tighten the nut to 60 N.m (44 lb ft).
4. Install the new idler arm nut.
Tighten the nut to 60 N.m (44 lb ft).
5. Connect the steering linkage outer tie rods to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement (See: Tie Rod/Service
and Repair/Steering Linkage Outer Tie Rod Replacement) .
6. Install the steering linkage shock absorber. Refer to Steering Linkage Shock Absorber Replacement (See: Steering Damper/Service and Repair) .
7. Adjust the front toe. Refer to Front Toe Adjustment (See: Alignment/Service and Repair/Front Toe Adjustment) .
