H2 V8-6.2L (2008)
7. Remove the O-ring seals (1) (4) (5).
8. Remove the magnet (3).
9. Clean the magnet (3).
10. Inspect the welch plug in the power steering pump housing (2). Do not remove the welch plug. If the welch plug is deformed or dislodged, replace
the power steering pump housing (2).
Assembly Procedure
Important: Use new O-ring seals when assembling the power steering pump assembly.
1. Lubricate the O-ring seals (1) (4) (5) with power steering fluid.
2. Install the flow control valve spring (7) to the pump housing assembly (2).
3. Install the control valve (6) to the flow control spring (7).
4. Install the O-ring seals (1) (4) (5) to the pump housing assembly.
5. Install the magnet (3) to the pump housing assembly (2).
6. Connect the reservoir assembly (1) to the pump housing assembly (2).
7. Install the O-ring seal.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
8. Install the connector and fitting assembly (4) to the pump housing (1).
9. Install the 2 power steering pump mounting studs (2) to the pump housing (1).
Tighten the pump mounting studs to 58 N.m (44 lb ft).
10. Tighten the power steering flow control valve fitting.
