H2 V8-6.2L (2008)
Power Steering Line/Hose: Service and Repair
Power Steering Gear Inlet Pipe/Hose Replacement
Removal Procedure
1. Remove as much power steering fluid from the power steering reservoir as possible.
2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and Repair
) .
3. Place drain pans under the vehicle as needed.
4. Disconnect the power steering gear inlet hose (2) from the power steering pump (1) and discard the O-ring seal.
5. Disconnect the power steering gear inlet hose from the steering gear and discard the O-ring seal.
6. Remove the power steering gear inlet hose from the vehicle.