H2 V8-6.2L (2008)
Stabilizer Bushing: Service and Repair
Rear Suspension
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Remove the stabilizer shaft insulator bracket mounting bolts.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
3. Support the rear axle at curb height.
4. Separate the stabilizer shaft from the axle.
5. Remove the stabilizer shaft insulators brackets.
6. Remove the stabilizer shaft insulators.
Installation Procedure
1. Install the stabilizer shaft insulators to the stabilizer shaft.
2. Install the stabilizer shaft insulator brackets to the rear axle.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the stabilizer shaft bracket mounting bolts.
Tighten the insulator bracket bolts to 33 N.m (24 lb ft).
4. Remove the rear axle support.
5. Lower the vehicle.