H2 V8-6.2L (2008)
8. Place an alignment mark between the pinion and the pinion yoke.
9. Install the J 8614-01 as shown.
10. Remove the pinion nut while holding the J 8614-01 .
11. Remove the washer.
12. Install the J 8614-2 (2) and the J 8614-3 (3) into the J 8614-01 (1) as shown.
13. Remove the pinion yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1).
Use a container in order to retrieve the lubricant.
14. Remove the pinion oil seal. Use a suitable seal removal tool. Do not damage the housing.
Installation Procedure
1. Install a new pinion oil seal using the J 22388 or the J 44414 .
2. Apply sealant, GM P/N 12346004 (Canadian P/N 10953480) or equivalent, to the splines of the pinion yoke.
