H2 V8-6.2L (2008)
6. Disconnect the boot from the groove on the transfer case output shaft.
7. Remove the propeller shaft from the transfer case output shaft by sliding the propeller shaft forward.
Installation Procedure
1. Inspect the splines of the transfer case output shaft for a sufficient coating of lubricant. If the output shaft does not have a sufficient coating of
lubricant, lubricate the shaft with lubricant GM P/N 12345879 (Canadian P/N 10953511) or with an equivalent lubricant meeting GM
specification 9985830.
2. Install the propeller shaft splines into the transfer case output shaft.
