H2 V8-6.2L (2008)
2. Install the adapter to the transmission.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the adapter mounting bolts to the transmission.
Tighten the mounting bolts to 50 N.m (36 lb ft).
Important: When installing the gasket to the adapter, make sure that the yellow printing on the gasket is facing toward the transfer case
(away from the transmission). The locating tab on the gasket should always be pointing up.
4. Install the new gasket to the adapter.
5. Install the transfer case to the adapter. Refer to Transfer Case Assembly Replacement (See: Service and Repair/Removal and
Replacement/Transfer Case Assembly Replacement) .
6. Install the crossmember in the vehicle.
Tighten the mounting bolts to 95 N.m (70 lb ft).
7. Remove the transmission jack from the transmission.
8. Check the fluid level of the transfer case. Refer to Transfer Case Fluid Replacement (See: Service and Repair/Removal and Replacement/Transfer
Case Fluid Replacement) .
9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
