H2 V8-6.2L (2008)
Wiper Arm: Service and Repair
Windshield Wiper Arm Replacement
Windshield Wiper Arm Replacement
Removal Procedures
1. Lift the wiper arm (1) and raise approximately 2 inches from the glass.
2. Release the locking tab at the base of the wiper arm (2) by sliding the tab outwards with a flat bladed tool.
3. With a flat-bladed tool, lift the wiper arm off of the post (3).
Installation Procedure
1. Align the key on the wiper arm pivot shaft with the detent on the wiper arm post (3), and with the locking tab in the open position, slide the wiper
arm (2) onto the pivot shaft.
2. Inspect the wiper arm is fully seated to ensure the locking tab is fully engaged.
