H3 L5-3.7L (2007)
Verify that the clip retainer arms have been seated fully into the console insert. Inspect the clip-to-clip console gap. If the clip retainer arms are not
seated, they will be wedged along the edge of the console. The illustration shows a properly seated clip.
DO NOT use more than 0.3 Nm (2.7 lb in) of torque on the three fasteners to avoid damaging the console. If more than 0.3 Nm (2.7 lb in) is used, the
screw will pull out of the console insert. If the screw pulls out of the console, the floor console will need to be replaced.
Attach the console lid and the hinge to the console. Insert the middle screw (1) first and then insert the left and right screws.
Tighten
Tighten the screws to 0.3 N.m (2.7 lb in).
Verify the operation of the console lid.
Open the console lid.
Push the console lid to the rear of the vehicle with about 7.4-11 N.m (10-15 lb ft) of force.
Inspect the hinge and console insert to ensure that the hinge is not lifting or separating from the console insert.
