H3 L5-3.7L (2007)
Fog/Driving Lamp Bulb: Service and Repair
Off Road Lamp Bulb Replacement
Off Road Lamp Bulb Replacement
Removal Procedure
1. Remove the 6 fastener covers by inserting a flat-bladed tool into the slot on the passengers side of each cover and gently lifting upward.
2. Using a T25 Torx driver, loosen the six bolts (1) under the fastener covers.
3. Rotate the lightbar rearward so that the light bar is laying upside down on the roof.
4. Remove the bulb socket from the lamp assembly by rotating 1/4 turn counterclockwise.
5. Pull the bulb outward from the lamp socket.
6. Replace the bulb.
Installation Procedure
1. Install the bulb socket into the lamp assembly by rotating 1/4 turn clockwise.
2. Rotate the light bar to the correct orientation.
Notice: Refer to Fastener Notice.
3. Install the fasteners.
Tighten the fasteners to 4.5 N.m (30 lb in).
4. Install the 6 fastener covers by aligning the tab to the drivers side and gently pressing inward into place.
