H3 L5-3.7L (2007)
Turn Signal Switch: Service and Repair
Multifunction Turn Signal Switch Housing Replacement
Multifunction Turn Signal Switch Housing Replacement
Removal Procedure
Caution: refer to restraint system service precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the steering wheel from the steering column.
3. Remove the steering column trim covers.
4. Remove the turn signal multifunction switch.
5. Remove 2 washer head screws from the switch mounting plate.
Slide the switch mounting plate from the steering column shaft.
Installation Procedure
1. Slide the switch mounting plate onto the steering column shaft.
Notice: Refer to Fastener Notice.
2. Install 2 washer head screws into the switch mounting plate.
Tighten the screws to 2.5 N.m (22 lb in).
3. Install the turn signal multifunction switch.
4. Install the steering column trim covers.
5. Install the steering wheel to the steering column.
6. Enable the SIR system. Refer to SIR Disabling and Enabling.
