H3 L5-3.7L (2007)
1. Slide the multifunction switch/SIR coil assembly onto the steering column.
Notice: Refer to Fastener Notice.
2. Screw the 3 pan head tapping screws into the multifunction switch/SIR coil assembly.
Tighten the screws (1) to 4.5 N.m (40 lb in).
3. Route the wire harness assembly down the steering column.
4. Connect the multifunction switch/SIR coil assembly connector at the base of the column, the ignition switch, and the ignition lock solenoid.
5. Install the wire harness straps to the wire harness assembly.
6. Remove the centering tab from the multifunction switch/SIR coil assembly.
7. Install the steering column trim covers.
8. Install the steering wheel to the steering column.
9. Enable the SIR system.
