H3 V8-5.3L (2008)
Ignition Switch Lock Cylinder: Removal and Replacement
Ignition Lock Cylinder Replacement
Ignition Lock Cylinder Replacement
Removal Procedure
1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Trim Covers Replacement) .
2. Turn the ignition lock cylinder to the accessory (ACC) position.
3. The ignition lock cylinder access hole is just under the inflatable restraint steering wheel module coil on the right center of the steering column
housing.
4. Insert the 90 degree tip of a pick type tool into the ignition lock cylinder access hole.
5. Push down and hold the ignition lock cylinder retaining pin.
6. Remove the ignition lock cylinder by pulling it out of the steering column.
Installation Procedure
1. Install the ignition lock cylinder by performing the following procedure:
1. Turn the ignition lock cylinder to the accessory (ACC) position.
2. Push the ignition lock cylinder until the ignition lock cylinder retaining pin locks in place.
2. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Trim Covers Replacement) .
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
Removal Procedure
Caution: Refer to SIR Caution (See: Restraint Systems/Service Precautions/Technician Safety Information/SIR Caution) .
1. Disable the supplemental inflatable restraint (SIR) system. Refer toSIR Disabling and Enabling (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair) .
2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (See: Ignition Lock Cylinder Replacement) .
3. Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Multifunction Turn Signal Switch Housing Replacement) .
4. Remove the ignition lock cylinder case bolt using a hammer and chisel.
5. Remove the ignition lock cylinder case.
Installation Procedure
