Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
Axle Shaft Assembly: Service and Repair
Disassemble
Fig. 10 Exploded View Of Front Driveshaft
1. Remove Double Offset Joint (DOJ) boot band, Fig. 10.
2. Remove DOJ boot from DOJ outer race.
3. Using screwdriver, remove circlip.
4. Remove DOJ outer race, then wipe off grease.
5. Remove snap ring, remove DOJ inner race, cage, then the balls as an assembly. Clean assembly. If balls drop out of cage, reinstall with inner race.
6. Wipe grease off spline portion.
7. Remove Birfield Joint (BJ) boot band.
8. Remove DOJ and BJ boots. If boots can be reused, wrap vinyl tape around driveshaft spline so that boots are not damaged as they are removed.
9. Wipe grease off BJ. Do not disassemble.
10. Inspect all components and replace as necessary.
