Genesis Coupe L4-2.0L Turbo (2010)
16. Check if the gap is within specification. If the gap is OK, complete the procedure. If it is not, go to the next step.
17. Lightly loosen the front bumper upper side bracket mounting bolts (J), and fully push the bracket up and tighten the mounting bolts (J).
18. Check if the gap is within specification. If the gap is OK, complete the procedure. If it is not, go to the next step.
19. Remove the front bumper upper side mounting bracket (K) by unfastening the 2 bolts.
NOTE:
Tightening torque: 0.5~0.6kgf.m (1b.ft.)
20. With a file (N) file the side mounting bracket holes and guide pin holes (L, M) to be expanded downward.
IMPORTANT:
Do not file both sides of the hole. Properly file holes according to the gap error difference. Red portions (L, M) should be filed.