Genesis Sedan V6-3.8L (2009)
8. Pull out solenoid valve connector and the O-ring after removing the bolt.
9. Pull out the transmission wire through the hole for the connector.
CAUTION:
Be careful not to damage the connector and sensor on the wire.
Installation
1. Insert a new "O" ring to the transmission wire and install the wire through the hole on the transmission case.
O-ring size:
inner dia.-21.80mm(0.858in),
thickness-2.40mm(0.0945in)
2. Install the bolt to place the connector on the transmission case.
Tightening torque :
4 - 7 Nm(0.4 - 0.7 kgf.m, 2.89 - 5.06 lb-ft)
Bolt size(5) :M6x1.0x21mm
3. Install the ATF temperature sensor and the lock plate with the bolt to the valve body assembly.
Tightening torque :
8.2 - 12.0 Nm(0.82 - 1.20 kgf.m, 5.93 - 8.68 lb-ft)
Bolt size(11) :M6x1.0x12mm