Santa Fe L4-2.4L (2001)
7. Check to ensure that the timing marks are in alignment.
Specifications
8. Verify the tension of the timing belt.
Method 1: Verify that, when the center of the span on the tension side is depressed with an index finger in the direction of arrow, the deflection of
the belt is within specification.
Belt deflection: 5 - 7 mm (0.20 - 0.28 inch)
Method 2: Measure the tension of the timing belt by using a tension gauge.
9. Install the flange and crankshaft sprocket onto the crankshaft. Be sure to install the as shown in the illustration.
CAUTION: Pay attention to the direction of the flange. If it is installed in the wrong direction, a broken belt could result.
10. Install the special washer and sprocket bolt to the crankshaft and then tighten the sprocket bolt.
Tightening torque
Crankshaft sprocket bolt 160 - 170 Nm (1600 - 1700 kg.cm, 116 - 123 ft. lbs.)
11. Insert a screwdriver through the plug hole in the left side of the cylinder block to keep the shaft in position.
