Santa Fe L4-2.4L (2001)
12. Install the oil pump sprocket and tighten the nut to the specified torque.
Tightening torque
Oil pump sprocket 50 - 60 Nm (500 - 600 kg.cm, 36 - 43 ft. lbs.)
13. Install the camshaft sprocket and tighten the bolt to the specified torque.
Tightening torque
Camshaft sprocket bolt 80 - 100 Nm (800 - 1000 kg.cm, 58 - 72 ft. lbs.)
14. Install the auto tensioner.
CAUTION: Leave the set pin installed in the auto tensioner.
NOTE: If the auto tensioner rod is in its fully extended position, reset it as follows.
1. Clamp it in a vise equipped with soft jaws, in a level position. Use a plain washer if there is a plug at the bottom of the auto tensioner
2. Compress the rod slowly with the vise until the set hole in the rod is aligned with set hole in the cylinder
3. Insert a set pin through the auto tensioner body and rod.
CAUTION: Leave the set pin installed in the auto tensioner.
