Santa Fe V6-3.5L (2004)
2. After disconnecting the mounting screws, pay the reservoir free from the master cylinder.
3. Using a snap ring pliers, remove the retainer.
4. Remove the primary cylinder pin. Push the primary piston with a screwdriver and remove the primary piston assembly.
5. Remove the secondary cylinder pin. Push the secondary piston with a screwdriver and remove the secondary piston assembly.
NOTE: Do not disassemble the primary and secondary piston assembly
INSPECTION
1. Check the master cylinder bore for rust or scoring.
2. Check the master cylinder for wear or damage. If necessary, clean or replace the cylinder.
NOTE:
1. If the cylinder bore is damaged, replace the master cylinder assembly.
2. Wash the parts in alcohol.
REASSEMBLY