Santa Fe FWD V6-3.3L (2009)
11. Fix the driveshaft (A) with a vice (B) as illustrated.
12. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is
removed.
13. Saperate the dynamic damper (A) from the shaft (B) carefully.
14. Using a plier or flat-tipped (-) screwdriver, remove the clamp on the side of wheel.
15. Pull out the joint(BJ) on the side of wheel into the transaxle direction.
Be carefull not to damage the boot.
Reassembly
1. Wrap tape around the driveshaft splines (PTJ. side) to prevent damage to the boots.
2. Apply grease to the driveshaft and install the BJ boots.
3. Install the bands to both BJ boots.