Sonata L4-2.0L (1992)
6.
Install a new oxygen sensor and torque to 29 - 36 lb.ft.
7.
Lower the vehicle to the ground.
8.
Connect the oxygen sensor connector to the engine wiring harness.
Connect the negative battery terminal and reset the radio stations and clock.
9.
An authorized Modifications Label will need to be applied to the under side of the hood. Wipe the surface clean before applying the new label.
10.
On the Authorized Modifications Label, you will need to write in the following information:
CHANGE AUTHORITY: 020
DEALER CODE: YOUR DEALER CODE
REPAIR DATE: THE DATE OF THE REPAIR
Remove the backing from the clear adhesive on the front of the label, and press down on the label.
11.
Open the driver's door and place a punch mark over the 10th character on the B-Pillar or the Door identification plate. This will indicate that the
campaign procedures have been completed.
12.
Fill out the California Vehicle Emission Recall - Proof of Correction form as shown below:
1992 ELANTRA AND SONATA
OXYGEN SENSOR
EMISSION CAMPAIGN
California residents who own an affected vehicle may be required to send a Vehicle Emission - Proof of Correction form to the Department of Motor
Vehicles (DMV) as evidence of recall completion when they apply for vehicle registration renewal. Each customer whose vehicle is registered within
California must be given a completed Vehicle Emission Recall - Proof of Correction form after the recall has been completed. Packages of this form
have been sent to California dealers along with this bulletin. Additional forms are available by contacting your Field Technical Managers (FTM).
Note:
This form MUST be completed by the Dealership's Service Manager using a permanent ink pen. A fine point pen is recommended. When filling in
the information, copy the information directly from the vehicle, NOT the repair order.
ALL INFORMATION MUST BE PRINTED AND NEAT.
