Tucson AWD L4-2.4L (2010)
12. Install in the reverse order of removal.
CAUTION:
-
Use a pry bar (A) being careful not to damage the transaxle and joint.
-
Do not insert the pry bar(A) too deep, as this may cause damage to the oil seal.
-
Do not pull the driveshaft by excessive force it may cause components inside the joint kit to dislodge resulting in a torn boot or a damaged
bearing.
-
Plug the hole of the transaxle case with the oil seal cap to prevent contamination.
-
Support the driveshaft properly.
-
Replace the retainer ring whenever the driveshaft is removed from the transaxle case.
Components and Components Location
Component location
Components